Amplifiers ▪ Tubes ▪ HF
OM4000A Price no Tax ±: 4.168 € updated jan 2016| F E A T U R E S | |
|---|---|
| Frequency coverage, included Warc (MHz) | 1.8 – 29.7 MHz including WARC |
| Power PeP HF (SSB/CW in W) - HF Rtty, digital mode, FM, - and VHF | 4000W in SSB and CW, 3000W in RTTY, AM and FM |
| Power Pep VHF (SSB/CW in W) | |
| Power input (W) - Power out Low, Medim, High | Usually 60 to 90W for full Output Power |
| Change band | Automatic |
| Alc | |
| Alphanumeric Display (W, A,band, T°, R.o.s. alarms, ect.) and/or Bar display and/or analog instrument | Current at control grid (Ig1) - 2 LEDs
-WAIT – preheating of tube (150 sec.) -STBY - standby -OPR – operation mode -FAULT – failure, switching off for abt. 2 sec. -INHIBIT – operating condition -ANT 1 - which ANT is in use -ANT 2 – which ANT is in use -ANT - ANT selection Bar graph indications: - Power output – 50 LEDs - Reflected power – 20 LEDs - Ig2 current - 10 LEDs - Anode voltage, anode current, tuning – 30 LEDs |
| CAT (Icom, Yaesu, Kenwood, ect.) | Full compatibility with - ICOM - YAESU - ELECRAFT - Ten-Tec Orion - Kenwood - Icom transceive protocol using by microHAM devices –CI-V output (MK II, MK2R, MK2R+, etc) - Flex Radio Series 6xxx |
| Power Tube type | 2x FU728F Ceramic Tetrode |
| Low pass filters | |
| Harmonic suppression (less..); Harmonic 3' Order Suppression | < -50 dBc |
| Remotely Controllabl | |
| Automatic Tuner, time, banda Ros | |
| Insertion loss with/out ATU | |
| TX SO-239/RX SO-239 | 2 |
| Interface (I/O, …) | |
| Cooling fans(dBmax) | Centrifugal blower + Axial blower |
| Power supply | 2 x 230V – 50 Hz one or two phases |
| Type circuit power supply; Maximium Power | Transformers: 2 pcs of toroidal transformer 3kVA |
| Compliance; preparing different market | |
| Kit (Cables. bag, Software...) | |
| Warranty | |
| Size (WxHxD,cm) | 485 x 200 x 455mm |
| Weight (kg) | 46kg |
| Microprocessor controll | |
| Availability Accessories | |
| Opzional | |
| Notes | Protections: VSWR too high
-Input power too high -Output power too high -Plate voltage too low -Anode current too high -Screen current too high -Grid current too high -Mistuning of PA -Hot switching protection -Soft start for protecting your fuses -switch-on blocking “ at opened amplifier |
| Marketing year beginning |
Photos
